Rc522 Proteus Library

In newer Proteus versions, you can use the Library Manager (System > Library Manager) and select "Install from local package" if the library is packaged correctly.

The RC522 module communicates primarily over the Serial Peripheral Interface (SPI) bus. Here is how to wire the virtual RC522 module to an Arduino Uno within Proteus for a standard simulation setup. RC522 Pin Name Arduino Uno Pin Description SPI Slave Select (Chip Select) SCK SPI Serial Clock MOSI SPI Master Out Slave In MISO SPI Master In Slave Out IRQ Unconnected Interrupt Request (Not needed for basic setups) GND Ground Connection RST 3.3V VCC (3.3V) Power Input (Note: Physical RC522 is not 5V tolerant) Adding Simulation Visual Aids

Even with a properly installed RC522 library, you may encounter problems: rc522 proteus library

: Connect Arduino TX (Pin 1) to the Virtual Terminal RXD , and Arduino RX (Pin 0) to the Virtual Terminal TXD .

Click the (Pick Device) button in the component selector. In the Keywords search box, type "EM18" or "EM-18". If the installation was successful, the component should appear. If it doesn't, you may have placed the files in the wrong directory or missed a required file. In newer Proteus versions, you can use the

void setup() Serial.begin(9600); SPI.begin(); mfrc522.PCD_Init(); Serial.println("Scan a virtual card...");

// Select one card if (!mfrc522.PICC_ReadCardSerial()) return; RC522 Pin Name Arduino Uno Pin Description SPI

#include <SPI.h> #include <MFRC522.h>

Even with a correct RC522 Proteus library, you will encounter issues. Here are the top 5 problems and their solutions.