Manual: Castrol Lubecon Advanced System Controller

Ensure adequate clearance on the bottom of the enclosure for conduit entry.

Refill the tank with authorized Castrol LubeCon lubricant. Test the float switch continuity. Short circuit in the solenoid coil or field wiring.

Check incoming 24VDC power supply from the central pumping station. Low lube level or system fault castrol lubecon advanced system controller manual

Connect the primary proximity sensor (used to detect chain links or carriers) to Terminal Bank IN-1 . Ensure the shield wire is grounded at the controller chassis only.

Multi-line backlit LCD or digital LED interface with tactile navigation buttons. Ensure adequate clearance on the bottom of the

Rugged thermoplastic or industrial steel options, designed for harsh environments.

The system will generate alarms and notifications in the event of system faults, low lubricant levels, or other issues. Short circuit in the solenoid coil or field wiring

Disclaimer: This article is a guide based on common features of the Castrol Lubecon Advanced System. Always refer to the specific manual provided with your unit for exact wiring diagrams and voltage specifications, as hardware revisions vary.

Inspect and clear downstream lines; flush nozzles with a clean solvent; verify operating temperature limits. Electrical noise interference; improper grounding.

“Do not hold TEST for more than 5 seconds during priming, as this may exceed the low-pressure switch threshold and trigger a false Line Rupture alarm.”

Secure termination points for main power, pump control, and sensors. Installation and Wiring Guidelines