Caraflo V200 Shower Instructions: ((install))
If the temperature is not 38°C, carefully pry off the plastic chrome cover cap from the center of the temperature control handle.
Rotate the temperature handle back and forth several times to release trapped water inside the mixing chamber. Leave it set midway.
Limescale has bound to the thermostatic cartridge. Remove the cartridge, soak it in a 50/50 mix of warm water and white vinegar for 30 minutes, lubricate the rubber O-rings with silicone grease, and reassemble.
If your water heater has a boost setting, activate it 15 minutes before showering to ensure you have a full tank of hot water ready. 3. Maintenance and Winterization caraflo v200 shower instructions
Place the temperature knob loosely back onto the splined brass spindle. If too cold: Turn the spindle slightly counter-clockwise. If too hot: Turn the spindle slightly clockwise.
: Unscrew the shower hose from the base of the V200 valve. Let any trapped water drain out into the basin.
Located on the right side of the valve.
The V200 does not need maximum pressure to work—it needs .
Pre-set at 38°C to prevent scalding. Pre-Installation Requirements
I can provide tailored troubleshooting steps to fix your exact problem. Share public link If the temperature is not 38°C, carefully pry
Caraflo V200 is a popular thermostatic shower mixer used extensively in static caravans and holiday homes (such as those by Swift or Willerby). Below are instructions for its installation, maintenance, and essential winter protection. Static Caravan Spares Installation Guidelines Positioning : The V200 can be fitted in either a horizontal or vertical orientation. Fixing Centres : The unit requires 45mm hole centres for mounting. Inlet Connections Connect the Hot supply to the inlet marked with 'H', a red/orange label, or "HOT". Connect the Cold supply to the inlet marked with 'C', a blue label, or "COLD". Prerequisite : Ensure all supply pipework is thoroughly flushed through
Close the main water feed taps, remove the shower hose, open the bottom valve, turn the top valve clockwise to drain cold water, then push in the red button and turn anticlockwise to drain hot water. This is the official full winterization procedure.
The internal flow cartridge needs replacement. This is separate from the thermostatic cartridge and handles the physical shut-off of water. Limescale has bound to the thermostatic cartridge
: Frozen residual water within a thermostatic cartridge will expand. This cracks the internal nylon casing or breaks the Vernet copper capsule. You must drain the system when closing your caravan for winter.
Extend the hot and cold copper or plastic barrier pipework through the wall, leaving approximately 20–25mm of pipe protruding. Step 2: Fitting the Concealing Plates